| 10/31/2025 | P-25-028509 - Product Improvement. This notice informs you that due to an enforced change by a vendor to a raw material, TE Connectivity is reformulating our S1297 adhesive tape and /97 adhesive pre-coat for heat-shrink molded shapes. TE Connectivity manufactures S1297 adhesive tape and /97 pre-coat adhesive from a compound material designed by TE Connectivity using raw materials sourced from external vendors. This reformulation change will follow our defined change procedure to maintain safety, quality, compliance, and to maintain the same or improved form, fit, and function | Download |
| 09/12/2025 | P-25-028788 - Manufacturing location change. The attached list of Part Numbers will be affected by the transfer of the manufacturing location for a raw material that TE Connectivity purchases from an outside vendor.
| Download |
| 08/22/2025 | P-25-028676 - Product improvement. change to the process to make the solution that is used to apply the /97 adhesive precoat for heat-shrink molded parts. Previously, all adhesive ingredients and the corresponding solvents were mixed in one step and then the solution was applied to the molded parts. The new process is to create a pelletized form of the same adhesive ingredients and then dissolve the pellets in the solvents. The adhesive solution is then applied to the molded parts by the existing process. The adhesive mix is still covered by the same strict quality guidelines TE requires for the existing material, so no there is no change to form, fit, or function, nor is there any deviation from TE s RW-2019 specification. | Download |